configuration.yaml
1# BME280 Sensor (Temperatur, Luftfeuchtigkeit, Luftdruck)
2# Benötigt I²C-Verbindung - korrekte Verkabelung und Pullups sicherstellen
3sensor:
4 - platform: bme280
5 temperature:
6 name: "${friendly_name} Temperature"
7 id: bme280_temperature
8 unit_of_measurement: "°C"
9 accuracy_decimals: 1
10 device_class: temperature
11 state_class: measurement
12 filters:
13 - offset: 0.0 # Kalibrierungs-Offset
14 pressure:
15 name: "${friendly_name} Pressure"
16 id: bme280_pressure
17 unit_of_measurement: "hPa"
18 accuracy_decimals: 1
19 device_class: atmospheric_pressure
20 state_class: measurement
21 filters:
22 - offset: 0.0 # Kalibrierungs-Offset
23 humidity:
24 name: "${friendly_name} Humidity"
25 id: bme280_humidity
26 unit_of_measurement: "%"
27 accuracy_decimals: 1
28 device_class: humidity
29 state_class: measurement
30 filters:
31 - offset: 0.0 # Kalibrierungs-Offset
32 address: 0x76 # Standard-Adresse, manche Module nutzen 0x77
33 update_interval: 60s
34
35# Benötigte I²C-Konfiguration (zur Haupt-Config hinzufügen falls nicht vorhanden)
36# i2c:
37# sda: GPIO21 # Pins für dein Board anpassen
38# scl: GPIO22
39# scan: true
